Using the Elite PI Transfer program to update the firmware of an Elite PI screen

These following steps are all assuming that you have the Elite PI Transfer Control Center program installed on your computer and that the program is configured to communicate with all of the elevator screens on your property. If that is not done first, please reference one of our other guides or contact C.E. Electronics tech support at techsupport@ceelectronics.com

STEP 1.

Open the Elite PI Transfer Control Center program. Click on the "Add Task" button in the top left of the screen.

STEP 2.

Name the task "Code Update" or "Firmware Update", then under "Type" select "Code Update".

STEP 3.

Click on "Browse" and locate the .eep file that was sent to you from C.E. Electronics. Once you have selected the .eep file, click on "Displays".

STEP 4.

Select the screen that you need to send the code update to and click "Create and Run"

Once you click "Create and run" you will see the new task created in the main transfer page. The screens listed under the task will all turn green if the code update was pushed successfully. If the screens turn red, then there may be a communication or network issue and you should then contact C.E. Electronics tech support.