Use the Mikrotik Winbox software to check if you can see your ENET networking router

To check to see if your PC can view the ENET networking router, you can use a piece of software from MikroTik. Please follow these steps to check this.

Step 1.

Check to see if you already have the WinBox application on your PC. This application is typically installed during ENET networking setup, so there is a good chance that you already have it. At the bottom of your screen, in the search bar, search for "Winbox64". If you see it, click "open" to run the application. If you do not see it, go to step 2

Step 2

If you do not have the WinBox application already installed on your PC, you can download it from this link

https://mikrotik.com/download

Make sure that select the correct download. More than likely, you will be downloading the 64-bit option.

Now that you have downloaded it, you can go back to step 1 and open the application.

Step 3.

In the WinBox application, make sure that you are in the "Neighbors" tab. 

If you see an IP address with the Identity of ENET, then you are on the same network as your ENET and your PC can see and communicate with it. 

If you do not see anything listed here, then your PC can not see the ENET most likely due to being on the incorrect network gateway, or due to network restrictions put in place by your IT department.

If you do see an ENET listed here, but the IP address is showing 0.0.0.0, then this particular network was setup with DHCP network connections disabled. You will need to have your IT department contact techsupport@ceelectronics.com to configure the ENET networking router to a static IP address.